Door panel: door panel is made of stainless steel 304 with no frame. Core materials are paper honeycomb, aluminum honeycomb, PU, EPS and etc. The installation sites of door lock, door closer and hinge are reinforced with square tubes of more than1.5mmthickness which are compression moulded by special technology.
Door frame: it is made of completely stainless steel 304. The connection types with wallboards are double-clip type and aluminum connection. The former is applied mostly to machine made wallboard and the latter hand made wallboard. The accessories are double window and lift type sweeping bar. The lock can be famous door lock or the owners can select lock brands themselves.
Specification: common sizes 800X2100, 900X2100, 1500X2100 or1800X2100, can customize to customers` requirements, the materials can be selected according to customers` requirements such as306Lor other special materials.
Features: the stainless steel 304 door we produced are of elegant appearance, sturdy and durable, acid and rotting resistance and thermal insulation. It is the first choice for high-end projects at home and engineering concerning foreign affairs that requires for anticorrosion and high quality such as electronics factory and food factory
Hospital Sliding Door,Hospital Automatic Sliding Door,Hospital Sliding Glass Door,Hospital Sliding Ward Door Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hffreezerdoor.com
Application of High Temperature Heat Pump in Electroplating Plant Thermostat
Application of High Temperature Heat Pump in Electroplating Bath Thermostat I. Present Situation of Electroplating Factory 1. The electroplating factory now heats the cleaning solution of electroplating solution and parts, accounting for 20% -30% of the electroplating factory's total electricity. 2. Now electroplating heating methods are the following: A, small factories generally take electric heating B, medium-sized factories generally take boiler heating C, large enterprises generally use steam heating 3. After plating parts drying generally take electric heating Drying boxes, oil drying lines or steam drying lines. Second, Yong Gan high-temperature heat pump solutions: 1, the use of high-temperature air source heat pump, on the one hand to provide high temperature hot water 80 ℃ ~ 85 ℃, on the other hand heat pump exhaust can be introduced into the workshop for the workshop to provide fresh cold air, Workshop ambient temperature, improve the working environment of employees. 2, after plating parts can be high temperature air source heat pump for drying, parts drying at low temperature will not cause some plastic parts deformation and aging, to avoid damage to the product. 3, using high-temperature heat pump technology can reduce the plating costs per unit of product. Relatively calculated, the operating cost is electric heating 1/4, 1/3 of the cost of fuel, while improving the safety of production. High-temperature heat pump can effectively provide high-temperature hot water at 85 ℃ plating bath for the daily bath insulation, high-temperature heat pump exhaust outlet temperature stability at 20 ℃ -25 ℃, the exhaust recovery, the introduction of the workshop, the workshop can provide fresh Of the air-conditioning, lower workshop temperature, improve the workshop air quality, enhance the working environment. After plating parts can also use high temperature air source heat pump dehydration drying. The use of high-temperature heat pump technology can reduce the cost of electroplating, electrical heating is about a quarter of the cost of heating the equivalent of 1/3 the cost of fuel.