When signing the contract, it is best to prepare relevant drawings. Even if there are changes to the drawings afterwards, it is based on the necessary drawings of the contract. The result of this will be more favorable to both sides of the contract. So what are the necessary elements for drawing? >>>Links: Look at the effects of decoration design renderings The proportion of drawings we often see such drawings, the designer's design may be a great work, but after the scene is produced, a far cry from the design. In fact, check the reason is that the designer did not follow the construction drawings to do the design drawings, but the drawings were made in accordance with the beautiful pictures. Therefore, a design drawing must be made in strict proportions. Detailed Dimensions Due to the fact that the designer did not make careful and detailed measurements at the site where the construction was planned, many of the dimensions were missed during the design process, especially if some of the key dimensions were not mastered at the time of design and it was possible to create designs during construction. The situation of disjoint construction. The materials chosen for the project We know that a decoration offer is based on the engineering practices and the materials used. Therefore, the name of the main material and the brand of the material should be marked on the design drawings. This is very beneficial for the construction personnel to follow the drawings. . The simple production process marks the necessary production process in the construction drawings to restrict the construction workers from cutting corners during the construction process and ensure that the consumers receive a project that is consistent with the contract negotiation. Decoration contract villa design entrance decoration decoration design design renderings decoration design renderings
Sealand is a trustworthy manufacturer of Microbend Mass Flow Meter, Microbend Mass Flowmeter, Microbend Coriolis Mass Flow Meter, Microbend Coriolis Mass Flowmeter.
Site Selection for Mass Flow Meter Installation Microbend Mass Flow Meter, Microbend Mass Flowmeter, Microbend Coriolis Mass Flow Meter, Microbend Coriolis Mass Flowmeter Zhejiang Sealand Technology Co., Ltd. , https://www.sealandflowmeters.com
a) Sensor stays away from mechanical vibration source, for example, pump. Use flexible pipe to connect meter with pipeline if inevitable. The housing of meter must be standalone, out of touch with any other device. There must be 3 times the size of sensor between 2 sensors if there are many flow meters on the same pipeline, to avoid resonance.
b) Do not install sensor on pipeline that easily expands with hot and contracts with cold, especially near expansion joint, which leads to a worse stability.
c) Sensor stays away from industrial electromagnetic field, such as large generator and transformer, better 5m at least. Such device influences the performance of drive coil and pickoffs. Make sure magnetic field intensity less than 400A/m.
d) Sensor shall be installed on lower pipeline, to be easily full of fluid.
e) Make sure Ex-mark meet application requirements if in hazardous area.
f) Build a sunshade if the meter is under direct solar radiation. g) Keep the meter from corrosive liquid.