Going home to work is already tiring. If you are leaking from a water pipe, your mood is definitely bad. How do you deal with leaking water pipes? To solve this problem, we must first understand that the type of water pipe depends on whether it is an iron pipe or a plastic water pipe. There is also a degree of leakage of the water pipe: there is only a slight leakage, but there is a lot of water seepage, and sometimes the water pipe connector Leakage, the following I will solve the problem of water leakage of different levels for you to see how leaking water pipes leak. First, how to do water leakage? 1, if it is a PVC pipe, you can buy a PVC pipe to connect, first cut off the broken pipe, put the interface into the end of the pipe first, so that the other end of the cut position is exactly Keep it flush with the other mouth of the connector so that it is just straightened, and then send it directly to this end so that both ends have a certain amount of intersection and then distance (length). Then remove it and apply it with PVC glue directly. The inner side of the two ends and the outer side of the two down pipes. 2, you can buy waterproof tape to repair the water pipe, snagged on the line, and then use mortar waterproofing agent and cement cast on the line. 3, looking for a professional company is better if you can't handle it yourself. Second, how to do iron leakage? Iron pipe leakage, according to different situations using different methods 1, 2 cm diameter iron pipe leaks, but the iron pipe is not embroidered, but part of the location is damaged, the total pipe valve is closed, only need to replace the location of the iron pipe can be! Cut off the location of the water pipe, in the use of the equipment used in the thorough Screws, connect the head in the street! 2. The leakage of iron pipe with a diameter of 2 cm is caused by the corrosion of the entire pipe. The main valve of the pipe is closed, and the entire pipe is replaced with a two-piece pipe. 3, 20 cm in diameter iron pipe leakage, if it is a problem with the connector to replace the connector part. If it is a leak in the pipe body, the original pipe body is embroidered and repaired by welding. Note that a piece of iron plate closely fitting with the water pipe is required to be reinforced in the repair position. Third, how to do PPR plastic pipe leak? 1. First saw the leaking place with a small hacksaw - saw the mouth flat. 2. Gently polish the newly exposed port with sandpaper, not too much. 3, wipe the port clean with a clean cloth. 4. Use a special glue on the port and let it dry for a while. At this time, apply glue on the "bamboo" joint. 5, the port and "bamboo" connection, to repeatedly rotate until firmly. The same way to connect to the other end. 6, after all OK in the joints and then apply a proper amount of glue to ensure no leakage. The above is related to the introduction of leaking water pipes. I hope to help you. For more information on leaking pipes, please continue to pay attention to information on this site. Toilet plumbing to clear the bedroom Tips expansion joint leaking water Tap leaking leak leaking Control Valve,Flow Control Valve,Pressure Control Valve,Directional Control Valve LIANGGONG VALVE GROUP CO.,LTD , https://www.lgvalvegroup.com
