Stainless Steel Cutting Board Rack
Cutting Board Rack,Cutting Board steel rack,Cutting Board Organizer rack,Stainless Steel Cutting Board Rack,Chopping Board Rack,Stainless Steel Chopping Board Rack, The materials are used 304 stainless steel, easy to clean, never rust!
Kichen Rack is made of high quality 304 stainless steel, This kind of material steel luxury, never rust, resist corruption, easily clean, safe, healthy and durable. Prevent rust or chemicals from contaminating food and damaging health
Cutting Board Storage Rack,Cutting Board Holder,Stainless Steel Cutting Board Rack,Chopping Board Rack Shenzhen Lanejoy Technology Co.,LTD , https://www.szcoolingrack.com
/*728*90 created on 2018/5/16*/ var cpro_id = "u3440131"; Home>Bearing knowledge>IKO bearing cooperation effect and demand IKO bearing cooperation effect and demand
The effect of the IKO bearing cooperation is that the stop ring and the rotating ring of the IKO bearing are fixed from the stop of the device (usually the IKO bearing seat) and some of the rotation (usually the shaft); then the load is transmitted under the rotating state. And the basic task of limiting the movement system relative to stopping the orientation of the system. /*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';
On-axis and IKO housings; tumbling IKO bearing requirements are fixed in three directions: radial, axial and tangential directions. Radial and tangential positioning is achieved by tight cooperation of the IKO bearing rings; As long as the positioning is selected in a small number of cases, the axial limit parts are usually selected; for example, the end cover and the retaining ring limit the axial orientation within the clearance range.
The professional professor pointed out that the following four points should be emphasized when selecting cooperation:
(1) The circumferential surface of the IKO bearing ring should have excellent support and uniform force; to reduce deformation; and give full play to the bearing capacity of IKO bearings.
(2) The ferrule cannot slide in the direction of the tangential direction in its cooperation appearance; otherwise, the cooperation surface will be damaged.
(3) It is necessary to be able to change the length of the shaft and the IKO bearing seat hole at the free end of the IKO bearing; that is, it is necessary to have the ability to swim in a certain range with the customary axial orientation.
(4) It is necessary to pay attention to making the IKO bearing device and disassembly simple; saving labor and time.
Recommend to friends comments close window Bearing related knowledge Bearing professor summarizes the work of one-way bearing inspection. Bearing production factors noise and countermeasure analysis bearing basic knowledge motor bearing noise analysis and processing of special environmental bearing steel
This article links to http://
Please indicate China Bearing Network http://
Previous:Common vocabulary of machinery (13)
Next: Bearings in grinding (2)
IKO bearing cooperation effect and demand
Source: Bearing network time: 2014-09-22