With the improvement of people’s living standards, automobiles have become the best tools for people to travel. However, the visual effects of automobiles give people the ability to rely on automotive coatings. Like other coatings, the color of automotive paint is based on the samples of paint. Or the color of the template, the general deployment method is as follows.

1. Firstly, pay attention to the cleanliness of the environment in the color-adjusting place, fire safety, and prepare color matching containers, tools and test instruments, such as clean mixing tools, standard color cards or templates, colorimeters, and color meters.

2, access to data, based on experience or use computer measurements to determine the color of the mix of the main color and color composition, preparation for pre-coloring preparations.

3. According to the variety and supply of automotive coatings supplied by the market, select the real primary color pigments or colorants required for the primary color coating and tinting.

4, first try with sample. First determine the number of colors containing the complex paint, in the initial determination of the weight of the various paints to participate in color matching, as a reference for the deployment of large samples. Weight measurement method is: the color paint to participate in the color, respectively, into the container, first said its gross weight, color is completed, and then called once, the difference between the two weighing, you can obtain a variety of colors to participate in color matching The quality of the paint.

5. In the color matching process, the color paints that participate in the color matching should be based on the color of a certain color paint that is similar to the color paint, and slowly add a small amount of paint of other colors. And constantly stirring, sampling at any time, control the model, tune to see, must be patiently deployed in order to make the matching color meet the requirements.

6, when the color paint, set aside half as a backup, in case of over-matching, you can add in, and then carefully redeployed.

7. If the sample is a dry model, wait for it to dry after mixing the paint. If the time is not allowed, it can be judged based on experience whether the dried paint film conforms to the original model before drying. If the sample is a wet sample, it can be fully blended after the sample paint, drop a drop in the preparation of the paint next to the contrast, while adjusting the edge until registration.

8. After the sample is registered, the number of paints to be formulated shall be initially determined, and the proportion of paints to be added to the paint shall be taken into consideration.

9, with color paint, should be in the sunny or under the standard light source, do not continue to observe the color, let the eyes rest for a while and then look. When comparing paints, each paint must be thoroughly mixed evenly, and then sampled and compared, so as to reduce errors.

10, color paint, the color paint used, the base material must be the same, otherwise it will cause resin precipitation, floating color, precipitation.