As people's concern for healthy living continues to increase, more and more families choose to install water purifiers. Water purifiers can fully purify domestic water and drinking water to ensure the safety of domestic water, so they are welcomed by the market. Then everyone knows how the water purifier is installed. Let's follow Xiaobian together to understand how to install the water purifier. 1. Punch or fix the water purifier at the selected location. The hole should be smooth and the depth and distance must be accurate. There must be no cracks or gaps or burrs around the hole. 2. Connect with water pipe. Turn off the main tap valve first, connect the water purifier, and stick the raw tape around the connector. Do not leak water. 3, connect concentrated water discharge. The pure water machine can directly put the sewage pipe into the sewage pipeline, leaving a certain space at the port to avoid the sewage backflow into the healthy home water purifier and prevent the “siphon†phenomenon of the sewage outlet; if the water purifier sewage pipe is directly put into the sewage The pipeline shall be equipped with a ball valve at the end of the sewage pipe, which can be used for sewage discharge from time to time. The sewage pipe can also be directly connected to the original tap. Sewage outlets and water purifiers must be well connected to the sewage outlet. 4. Connect the purified water outlet and the purification tap. If the flow rate is more than 1000 liters, you can directly use 4 in charge and universal tap; if the flow is less than 1000 liters, you can choose to use 4 change 2 connectors to connect with the purified water outlet, and connect with 2 points faucet through 2 points white PE pipe. When connecting the two in charge, cut the tube port first, then put on the nut, then insert the plug into the PE pipe, insert tightly, tighten the PE pipe beyond the nut 1CM to insert the connector 5. Install the faucet: If you want to install the faucet in the sink, the stainless steel sink can be used to open the hole. If you want to fix the faucet on the wall, you can fix the faucet to the wall with the right-angle faucet. The joint connection method is the same as (4), and the fixed part must be tightened so that it cannot be shaken. 6. Open the water inlet ball valve, and debug the water purifier (see the maintenance and maintenance procedures for the debugging procedure). Observe whether the joint is leaking. Observe the period at least for 2 hours. You can place a clean dry towel under the water purifier to check if it is clean. There is water seepage. The installation method of the water purifier has a certain degree of professionalism, and it is generally installed by a special technician. The installation of the water purifier has a certain influence on the later use. The above is the relevant content of the water purifier installation method diagram. Tips: More practical decoration knowledge, real scene with the shoot, please pay attention to the palm of this site (micro signal: mall_jia). Water purifier water purifier purchase water purifier brand The design of the towel rack should consider whether it is convenient or not, but also consider the waterproof problem. Home use towel rack , brass toilet paper holder Bathroom Series, made of high quality brass material,chrome surface corrosion resistance long lasting use for years and years, no worries about rusted and oxidized. Bathroom Accessories,Towel Rack Stand,Wall Mounted Towel Rack,Outdoor Towel Rack HESHAN CAIZUN SANITRAYWARE CO.,LTD , https://www.caizunsanitaryware.com
