Installation of air conditioning to punch, soot flue to stay holes, exhaust fans to stay enough space in the opening hole ... ... to drill a lot of holes, but the hole is too small, once in a while, I am afraid to do homework Will not think of this matter.

“When the hole is punched, the equipment needs to be cooled with water. Will the water be contaminated when the water flows down? Is it necessary to wet the floor?” said Lao Wang, some owners only need to install air-conditioning and exhaust equipment at the end of the renovation. The idea of ​​looking for a master to drill holes will inevitably increase the cost and difficulty of product protection. Then verify the hardware dimensions such as doors and windows are reasonable. If the bottom door of the sliding door of the balcony is only five centimeters higher than the ground, after the floor is installed, the bottom door of the sliding door will be lower than the floor. Not only is it unsightly, but also it is inconvenient to push and pull the door, but it is necessary to knock it out again. Stick to the wall of the sliding door frame. This is a dilemma faced by a landlord recently. If he raises the door frame in advance of the renovation, there will be no such trouble.

Pharaoh said that because the security doors, sliding door frames, window sills and other hardware connected with the wall, before the renovation should be examined whether the size of the actual use, temporary adjustment of the size will destroy the wall. The framework of anti-theft doors and windows should be cement mortar and wall together, so be sure to clear whether the replacement before the renovation, to be replaced in the hydropower phase to complete. Finally cracked out indoor cracks and irregularities

Newly-decorated rooms will consider re-doing walls, but few people will shovel out all the stucco on the wall. After all, this is a time-consuming and laborious and expensive job.

“Don’t wait for the cracking of the wall to think that the money can't be saved.” The person in charge of a decoration company said that he had recently released a budget for the renovation of second-hand houses, of which more than 6,000 yuan was spent on the old walls. On the way, the owner knew that the old wall had many problems and he readily accepted it. He suggested that prior to the start of construction of second-hand housing, firstly check the flatness of the ground and the hollowness of the wall surface, and identify areas where there is a problem. The wall surface will be redecorated from the grass-roots level and be crack-proof; the ground will have to focus on Waterproof layer and flatness, until the installation of the floor to realize that the ground is not smooth enough.

Entrance decoration children's room decoration window interior decoration space cement decoration interior decoration budget second-hand housing decoration budget

Roller Shutter Door

Roller shutter door , also known as "shutter door", lots of panel pieces connected together, fixed in the guide rail , take above reel as the center of rotation.

Roller shutter door is used for commercial facades, garages, shopping malls, hospitals, factories and mines and other public places or residential.Electric roller shutter door, especially for large openings, inconvenient to install the ground door , quick opening effect. Such as for the garage door, shopping mall fire shutter door.

Opening methods: Handing driving mode

Rope driving mode

Remote control driving mode

Electric switch driving mode

Roller Shutter Door,Galvanized Roller Shutter Door,Aluminum Roller Shutter Door,Transparent Roller Shutter Door

Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hfgaragedoor.com