Japanese researchers have optimized the design of synthetic diamond grown in the laboratory. This has led to further advances in biosensing applications such as enhanced brain magnetic imaging. The advantages of this sandwich-type layered diamond structure are described in the latest issue of the Applied Physics Letters of the American Association of Physics (AIP) Publishing Group. Chemical processes are used to create large pieces of diamond for industrial use. Synthetic diamond can be grown on a variety of surfaces to increase stiffness and reduce tool wear, or to utilize the high thermal conductivity of diamond as a heat sink for electronic devices. Scientists can manipulate the properties of synthetic diamond by changing the chemical composition. This chemical operation is called doping. These "doped" diamonds have proven to be an inexpensive alternative to a range of technologies from quantum information to biosensing. Otherwise, developing these technologies will be extremely expensive. Diamonds with a nitrogen-vacancy (NV) center detect magnetic field changes and are therefore powerful tools for biosensing technology and are used for medical testing and disease diagnosis. For example, magnetoencephalography (MEG) is a neuroimaging technique used to map brain activity and track pathological abnormalities such as epilepsy tissue. “MEG has commercial applications and is used in some hospitals, but it is so expensive that not many MEGs are used,†said Norikazu Mizuochi, one of the authors of the paper. Mizuochi explained that using diamonds with NV centers can reduce the cost of instruments for MEG diagnostics. However, these biosensing techniques require light excitation that induces NV center charge transfer. Since the uncharged NV center cannot accurately detect the magnetic field, the introduction of charge transfer has always been a challenge for diamond utilization. “Only negative charges can be used for this type of sensing application, so achieving stabilization of the NV center is very important for the entire operation,†Mizuochi said. Researchers have previously spiked phosphorus into a simple diamond structure to keep the NV center stable. Doped phosphorus pushes more than 90% of the NV center into a negative charge state, making magnetic field detection possible. However, phosphorus introduces noise into the readings and thus fails from positive results. In the latest study, the Mizuochi team adjusted the diamond design strategy to maintain a stable NV center, but removed the noise induced by phosphorus. They used a sandwich-like multilayer structure in which diamond-doped diamond was like bread and was surrounded by 10 micron thick NV center packing. This stabilizes 70% to 80% of the NV center in a negative charge state while reducing the noise previously seen in the system.
About high speed Door Accessories:
1.Driving system: High Speed Door Servo System motor and control, motor SNMA / SEJ +reducer+flang+encoder+control box
2.Other accessories: Middle aluminium bar, bottom aluminium bar, aluminium vertical track, stainless steel vertical track, brushes,round nylon strip, PVC roll, rolling steel tube complete, drum be;;s for rolling tube, side end covers, stainless steel cover, steel tubes, air bag sensor system, safety light beam, Microwave sensor 24 Gigahertz,PVC welding machine, smoke and fire sensors, PVC transparent window, magnetic loop, photocell, remote control, manual push button, sound warning alarm Led lamp traffic light
For some main accessories, here is detain introduction:
1).24G radar sensor:
Brand: Hofic
Technology: Microwave processor
Maintain time: 0.5s
Protection: IP54
Transmitting frequency: 24.125GHz
Maximum installation height: <5meter
Transmitting power density: <5mw/cm2
Power consumption: <1W(VA)
Installation angle: 0-90°(lengthways) -30-30°(crosswise)
Supply voltage: AC&DC 12V-30V
2).Photocell:
Approval CE & ISO9001
Power supply AC/DC 12-30V
Static current 25A
Action current 40mA
Mounting distance Max 10m
NO or NC contact Done by NO./NC. contact selection
Working environment temperature -42℃ to +45℃
Working environment humidity 10 to 90%RH
Appearance dimensions( controller) 123*50*32mm(L*W*H)
Appearance dimensions(Magic eye head) 19*13mm(L*D)
3). Remote control
Operating Voltage: AC220V/50HZ+-20%
Transmit power:≤100mW;Super regenerative module, strong anti-interference
Operating temperature:-30℃-+70℃
Working frequency: 433MHZ;transmitter 1527, millions of encoding chip
Accept sensitivity:≤110dB
Manipulation method: electric remote control
Configure the quantity: Wireless number; factory configuration transmitter two. Can be equipped with PT2272 digital decoder chip
Configure the function: Up, down, stop, anti-lock full-featured reproduction
4). Magnetic loop
Voltage: 12V AC/DC +-10% 24V 115V AC+-10% 230V
Power: <2VA
Continued electrical output: 7A / 250V AC
Frequency range: 20 to 200K Hz
Response time: infinity (factory setting) or adjust maintain time
Sensitivity: 0.01% to 0.1% divided into 3 levels
Protection level: IP30
Electromagnetic compatibility (EMC) Complies with EM50081-1 and EN50082-2
Detection loop inductance: the limit of 40uH to 100uH ideal value 80uH to 300uH
Operating temperature: -25 ℃ to 70 ℃
Storage temperature: -40 ℃ to 85 ℃
Relative humidity: <90% non-condensing
Temperature compensation: automatic compensation up to 50 ℃ / h
Connection type: 11 pin DIN rail socket
Dimensions: 41 * 78 * 85 mm (width * height * length)
Weight: 250 grams
5). manual push button
This exit switch button is made of ABS and has built-in indicator light make it looks more elegant and fashionbale. It can be widely used in public entrance gates, public door, home, office, hotel, etc.
Door Exit Button Push To Exit Switch Door Opener For Access Control Security
Main Feature
Fashionable appearance
Made of ABS Plastic
Easy to install and operate
Used for access control
Specification
Mechanical Life: 500,000 test
Material: Plastic
6). Limit switch encoder
Voltage: DC5V-24V
Output voltage: high voltage≥85%Vcc, low voltage≤0.5V
Maximum mechanical speed:6000rpm
Anti-vibration: 50m/s,10-200HZ,XYZeach way 2 times.
Current consumption:≤30mA
Response frequency: 0-100KHZ
Protection: waterproof,oil proof,dust prevention, IP54
The output code system: binary code
Operating life: MTBF≥30000(+25℃,2000rpm)
Rotational inertia:4.0x10-8kgm²
Maximum load:radial direction20N
Axial direction:10N
Weight: about 0.4kg
High Speed Door Accessories,High Speed Door,Electronic High Speed Door Accessories Shenzhen Hongfa Automatic Door Co., Ltd. , https://www.hfgaragedoor.com
Scientists have developed a new strategy for diamond synthesis that is more effective in biosensing applications!
Abstract Japanese researchers have optimized the design of synthetic diamond grown in the laboratory. This has led to further advances in biosensing applications such as enhanced brain magnetic imaging. The advantages of this sandwich-type layered diamond structure are in the latest issue of the American Physical Union (AIP) Publishing Group.