1. After installation, turn the high-speed shaft by hand to make the low-speed shaft flexible in both directions. Fire Rated Door,Fire Door,Fire Retardant Door,Fire Rated Access Doors Foshan QI'AN Fireproof Shutter Doors Co., Ltd , https://www.fsqianfiredoor.com
2. The reducer is generally lubricated with oil splashing oil and naturally cooled. When the heat balance power is insufficient for long-term continuous operation, heat dissipation measures or circulating cooling lubrication should be adopted. The lubricating oil is made of N110-N200 medium pressure gear oil. Semi-fluid grease is available for intermittent work. It should be run for two hours before the official use, and then loaded step by step according to the rated load of 25%, 50%, 75% 100%. The situation is normal, it should run smoothly, no impact, the maximum oil temperature does not exceed 80 ° C, the temperature rise does not exceed 60 ° C.
3. Change the lubricating oil after 300 hours of operation of the new reducer, and change it once in 3000 hours. When changing the oil, the inner wall of the reducer and the transmission parts should be cleaned.
4, should always check whether the firmware is loose, oil level, oil temperature and bearing temperature, gears, bearings should be free of abnormal vibration and noise.
5. The outer surface of the reducer should be kept clean and the vent plug should not be blocked for heat dissipation.
6. The gear unit must not leak when it is in use or unpacked and replaced.