Surface Grinder - Operating Instructions 1 : Surface grinder positioning Glass ceramic (glass-ceramic), also known as glass-ceramic, microcrystalline ceramic, by the famous glass chemist and inventor S. D. Stookey was invented in the mid-1950s and is a vitreous-containing polycrystalline solid phase material obtained by controlled nucleation and crystallization of a certain composition of base glass at a certain temperature. The properties of glass ceramics are mainly determined by the main crystalline phase, which can be achieved by controlling nucleation, crystallization, and selecting different parent glass components. Machinable Glass Ceramic Standard Parts Machinable Glass Ceramic Standard Parts,Standard Fuse Cutout Part,Mechanical Ceramic Parts,White Machinable Glass Ceramic Parts SHENZHEN HARD PRECISION CERAMIC CO.,LTD , http://www.hardcm.com
The machine tool should be reserved for more than 300mm outside the maximum movement space . Each foot screw is tight, and the front and rear sides of the table are within 0.04/1000mm . (The requirements for installing the inverter need to be higher)
Check every three months, adjust the level of the work surface, and tighten each foot screw.
2 : Surface grinder grinding wheel
The selected grinding wheel must be able to withstand a peripheral speed of 2000 m/min or more.
It is forbidden to use damaged wheels.
The new wheel must be balanced on the flange.
The grinding wheel needs to be idling for 5 minutes before the formal grinding .
The maximum feed rate is 800mm, the grinding machine is 0.03mm , and the 800mm or more grinding machine is 0.05mm.
3 : Surface grinding machine spindle
Before installing the grinding wheel, make sure that the spindle rotates clockwise.
When starting up, you must first open the spindle and then start flushing.
4 : Surface grinder hydraulic device
The surface grinder uses a hydraulic fluid with a viscosity of 46 .
The new machine needs to be replaced with hydraulic oil after three months of use, and then replaced once a year, and the tank must be cleaned.
Check the hydraulic oil level every day and the oil level should be between the lowest and highest line.
Before starting the hydraulic motor, make sure that the flow speed control lever is in the closed position.
Must first open the magnetic opening and then open the hydraulic pressure
5 : Surface grinder lubrication device
The lubricating oil uses a guide oil with a viscosity of 32 . (Recommended Mayweather 1 or 1405 )
Confirm the fuel tank (pool) oil volume every day to ensure that it is above the line.
Check the rail oil circuit for smoothness every week to prevent the rail from losing oil.
It is recommended to clean the tank every three months.
Grease is regularly refilled as specified.
6 : The left and right mechanism of the surface grinder
It is forbidden to adjust the left and right strokes while the table is in motion.
When the workbench cable is loose, it should be adjusted immediately. (This article applies to manual models)
7 : Surface grinder flushing and vacuuming device
The filter box filter must be cleaned every two weeks.
The cold water tank must be cleaned once a month.
Do not use air guns to clean surface grinders