Integrated All In One Solar Light Integrated All In One Solar Light,All In One Solar Light,Integrated Solar Street LED Light China Searun Solar Solution Co., Ltd. , https://www.srsolarlights.com
1. Set the problem 1) First idle to ensure that the motor can operate normally;
2) If you have any knowledge of the G and M codes, in the column on the right-hand side of Weihong control, is there any M03 at the beginning (the spindle rotates clockwise to start, in the Weihong control system, after the start of the motor Weihong control It will automatically rotate the spindle motor) and end the segment M05 (spindle stop rotation). Check if there is an M in the middle of your cutting code. Personally think that it is still more likely to have problems with software settings and software operations.
2, the motor burned you manually open the spindle to see if not turn, if you do not turn is the problem of the machine. If you turn, you can select spindle rotation and stop in the settings.
3, refer to the inverter manual, check the inverter display parameters.
4, if it does not work, please come after the after-sales service personnel of the machine manufacturer, will reinstall Weihong card system, generally can solve the problem.
Weihong's control system uses TYPE3 path to cause the engraving machine spindle not to rotate
What is Type3? It is a French three-dimensional relief software, conversion speed, relief effect is good. During the engraving process, the path is usually done in TYPE3, exported and imported from Weihong system. However, there is a time when Weihong's system uses TYPE3 to make a good path. As a result, the spindle will not turn when the engraving machine cuts. Everything else is normal. What should we do? Can analyze from the following aspects: